November 10 Man Scorpio

Update 2 to fix the carbide lamp carbide

The carbide lamp was very wind resistant, but unfortunately I have the flame within minutes, the glass vollgerußt so that the lamp has produced more shadows than light
:-( The solution seems to be to the glass with a small .. to install air gap to the reflector cut So once the hard drive sled, and produce with the aluminum strip spacers are the results:

In the hope that the wind I blow out the flame every few seconds had the whole course be tested immediately:

* pling * =) Note the Rußfahne over the lamp oO

And because the flame has such a nice color, here the whole thing without flash ;-)

The strategy seems to be the right thing, after 20 minutes the glass was not nearly as sooty as before. But I probably could increase the gap even more.

I also urgently needs a wind guard down at the opening facing toward the ignition, so I can light the lamp during the ride back, but if they lose interest. This happens especially like to curbs and other strong shocks oO